Mill Wall Heater Stand

Hello everyone! Finally back again with a new model!This is a vertical stand for the Mill 250w heater, but could work with other heaters too.Print the piece twice and have one at each side of the back strip (as shown in pictures)The total print time of both the parts is around 1 hour and 50 minutes on my BambuLab A1. Uses a little hook on structure at the top so they do not fall off when carrying it around, and the small half circle at the bottom makes sure that the heater has a smaller chance to tip or the print brakes. PRINTER AND FILAMENT TYPE Printer: BambuLab A1 ComboFilament: Chlas Ohlson PLAColor: Gray RECOMMENDED SETTINGS Layer Height: 0,24 mmIroning: NoWall generator: ArachneWall loops: 2Infill: 15%Support: NoInfill gap: 100%Rib wall: No