Thingiverse
Gadgets
Go to Model
Millenium Falcon keyring RFID
385
Downloads
263
Likes
4
Makes
This is a remix of the millenium falcon but with a recess 25mm diameter for a standard RFID for a keyfob.
It is important to print this one with smooth bottoms flat so glass bed is best.
The 25mm recess has an asymmetric fillet 1.5mm x 12mm to allow the layers to build up
the overhang WITHOUT needing support. DON NOT CHECK SUPPORT!!!
There are 3mm holes to allow dowel alignment if you prefer but it doesn't need it as long as you bond carefully in place. Bond with epoxy only for maximum strength.
Enjoy!!
It is important to print this one with smooth bottoms flat so glass bed is best.
The 25mm recess has an asymmetric fillet 1.5mm x 12mm to allow the layers to build up
the overhang WITHOUT needing support. DON NOT CHECK SUPPORT!!!
There are 3mm holes to allow dowel alignment if you prefer but it doesn't need it as long as you bond carefully in place. Bond with epoxy only for maximum strength.
Enjoy!!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
