Milwaukee M12 flashlight with adjustable head

This is a flashlight for Milwaukee M12 battery. It has a head with an adjustable angle, made from MR16 led bulb.

**BOM**

To assembly it, you will need:
- 3d printed lamp head.
- 3d printed upper piece of the body.
- 3d printed lower piece of the body.
- 3-5W MR16 led bulb with a radiator with M28x1 thread (see photos)
- 2x 8mm length M3 screw
- 3x 16mm length M3 screw
- 2 pieces of [6.3mm spade male connectors](https://www.aliexpress.com/item/20pcs-lot-6-3mm-Copper-Male-Wire-Splice-Crimp-Terminal-L15-Spade-Connector-Free-Shipping-Russia/32655259302.html)
- 1 piece of [21x15mm rocker on/off switch](https://www.aliexpress.com/item/5pcs-KCD1-perforate-21-x-15-mm-6-pin-2-positions-boat-rocker-switch-ON-OFF/32729944207.html)
- 10cm of 2-wire cable
- soldering iron

**Notes**

My led bulb uses almost 5 Watts and gets really hot (over 60°C) so printing lamp head with plain PLA may be not enough. I used PETG and it is holding ok. PLA could be probably used after "baking".