Milwaukee Packout Rail bracket

This is a clean and simple Milwaukee Packout Rail bracket. It is probably the most cost affordable design out there as there are no addition screws, nuts, or extras to purchase. Print Instructions:Please print 1 at regular orientation AND 1 Rotated 180 Degrees so that when installed, the top pattern and bottom patterns are visually the same. Materials List: Lowes Item Number: (Model # 11317) 2in X 3Ft Interior/Exterior Mill Finished Aluminum Solid. Approx $15.00Assembly Instructions: (Measuring for cut)Since everyone's settings are slightly different, here is what I did to achieve the perfect cut for the aluminum barRemove Milwaukee guide rod screw, and pull rods down, (no need to remove fully)Each 3D printed bracket (aluminum bar slot is 30MM) when measuring for the cut. Install 1 bracket slide aluminum bar into the other bracket (that's not yet installed)The Aluminum bar will extend past your other bracket, when you install make a mark on the aluminum bar where the bar meets