Thingiverse
Minatures Paint Shaker
door Nekology
34
Downloads
43
Likes
0
Makes
Needed a quick paint shaker for my miniatures paints, this will shake anything from 17ml dropper bottles right up to the 200ml air brush bottles from Vallejo. I haven't tried it on anything bigger than that.
The paints are held in the cradle by elastic bands around the cradle and the paint.
The 5 Bearing recesses are for 4mm x 9mm x 4mm Double Shielded 684-2Z bearings.
The motor is a super cheap 12v (dimensions in the images). The crank is push fitted onto the spindle with a dab of CA glue.
It's made to have M4 screws through all the linkages, countersunk sit better in the centre of the bearings. (the motor to link screw and the link to rocker screw are approximately 20mm in length, the cradle screw which goes right through the main bush can be up to 60mm, depending on if you use thrust bearings or washers between the printed parts, I found threaded rod applicable here with two nuts).
Where two surfaces meet, for example between the linkage and the rocker I would sugges
The paints are held in the cradle by elastic bands around the cradle and the paint.
The 5 Bearing recesses are for 4mm x 9mm x 4mm Double Shielded 684-2Z bearings.
The motor is a super cheap 12v (dimensions in the images). The crank is push fitted onto the spindle with a dab of CA glue.
It's made to have M4 screws through all the linkages, countersunk sit better in the centre of the bearings. (the motor to link screw and the link to rocker screw are approximately 20mm in length, the cradle screw which goes right through the main bush can be up to 60mm, depending on if you use thrust bearings or washers between the printed parts, I found threaded rod applicable here with two nuts).
Where two surfaces meet, for example between the linkage and the rocker I would sugges
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
