MINCRAFT CREEPER!

Two-piece Minecraft Creeper 3D model featuring a separate head and body that click together securely. Designed for easy printing with no supports required.Basic PLA Settings (Rough Guide)TemperaturesNozzle: 195–210°C(Start at 200°C—go up if layers don’t stick, down if stringy.)Bed: 50–60°C(Start at 60°C for best adhesion.)SpeedsPrint Speed: 45–60 mm/sFirst Layer Speed: 20–30 mm/sTravel Speed: 100–150 mm/sCoolingFan: 100% after the first few layersFirst 2–3 layers: 0–30% to help bed adhesionLayer SettingsLayer Height:0.2mm (good balance for most prints)0.16mm or 0.12mm if you want more detailInitial Layer Height: 0.2–0.28mm for easier adhesionRetractionBowden: 4–6 mm @ 45 mm/sDirect Drive: 0.8–1.5 mm @ 25–35 mm/sIf you get stringing → increase retraction or lower nozzle temp.AdhesionBed Surface: Clean with IPAAdhesion Type:Brim for small partsSkirt for most printsZ-offset: Make sure the first layer squishes slightly, not scraping.Filament TipsKeep PLA dry (store in airtight bag or dry b