Minecraft Armor Stand Tech Charger

READ THIS BEFORE YOU PRINT!!! You will not need every plate, only the ones for the electronics you have. Instructions: Before you do any printing, look at your electronics. For the earbuds (aka boots), you only need the case for the earbuds you have. Note: these chargers do not work if you have a case for your earbuds. For the watch (aka leggings), you only need the holder for the watch you have (if you don't have a watch then you don't need to print the holder) Alright, go print it now, but MAKE SURE YOU COME BACK AFTER! You still have to assemble the armor stand and put the armor on. After-print instructions: Grab the base and the 2 long legs. Put the pegs in the holes in the base and add a little glue. Next, grab the holder piece with the long clip and align the pegs with the holes on the long leg pieces from the last step, and add a little glue. Next, grab the 2 short chest pieces. Put the pegs into the holes on the last piece and add a little glue. Grab the big shoulder piece and