Minecraft Chess Set (Magnetic)

#Minecraft Chess Set (Magnetic)

This is a Minecraft Chess Set with magnets in each piece. I used most pieces from PotatoFi's set found here,

https://www.thingiverse.com/thing:143991

With the addition of a crown from Will Schleter's additions here,

https://www.thingiverse.com/thing:922419


I used a Pumpkin Head for the King/Enderman.

I created a round base with a cutout on the bottom for a 4x2mm magnet for use with the King/Queen/Enderman and Bishop/Skeleton.

I replaced the Rook/Creeper, Pawn/Slime and Knight/Zombie Body with versions that also have a cutout for a 4x2mm magnet on the bottom.

I found that the friction fit of the heads on these models is very filament dependent. You will likely have to experiment between 100%-110% in order to get the heads to friction fit well.

I also found that printing a single head did not allow enough drying time between layers of the head pin, the headpin would deform, and therefore printing 3 or 4 heads at a time was requ