Minecraft Pumpkin and Jack-o-lantern, reduced support version


__ * * * NEW FOR 2018! [MINI NO-SUPPORT VERSION IS HERE](https://www.thingiverse.com/thing:3117142)!!!__

[My original Minecraft Jack o'Lantern](https://www.thingiverse.com/thing:488574) required a lot of support to print, and it was not fun to remove. This design prints in two parts that can be snapped together with only about half as much support needed.

Print the base without support. The other parts will probably need support, depending upon your printer's ability to print overhangs.

You will probably need about 25% infill to avoid certain thin parts snapping off while you assemble.

*Please assemble the "face" and the "jaw" with great care! Slide the top onto the base straight down -- try not to let one side slide down before the other, or else the small parts on the corners may snap off. If they do snap off, glue it together and blame me.*

Don't use a real candle of course -- consider either these [flick