Minecraft Redstone Ore Lamp Redone

Disclaimer: I am just two months into learning about 3d printing...

I Liked this idea for a Redstone Lamp. But being a little OCD, I noticed that some of the side cutouts were rotated 90 degrees.

I corrected this in TinkerCAD. When I printed it, I didn't like how the automatically generated supports worked out (or didn't work so well), from Cura, and I just happened to be reading about designing supports... So I remixed it again with my own supports, which work a lot better I think. You should not require supports.

***To finish this model, push out the supports and cut out the small temporary bridges.***

I then remixed the Lid, because I thought the outside lip (at 1 mm thick) was too thin and too loose. I also made it thinner in the body of the lid. I adjusted the height of the boxes to keep the finished model a perfect cube of 70mm.

Lastly, for my 7 year olds birthday party, I made another stl to hold some LED lights that I bought (link below). This final file has a t