Minecraft Sword Night Light

My kids love minecraft and we had an extra LED light strip (270mm x 25mm) around the house so I decided to make a minecraft sword to go over the LED light strip. The solid pieces are all PLA but the translucent “light” pieces are PETG.The base had to be split into two pieces to fit onto the A1 mini print bed, so I utilized the dovetail cut option and glued it together afterwards. Assembly instructions: Glue the two base pieces togetherNext connect the following black pieces into the hilt guard.Next push in the remaing black pieces in this area and add the solid purple pieces. *Note the orientation of the large purple pieces. the notch should point towards the light strip hole.Next add the purple pieces along the edge of the blade. Again, orient the pieces so the notch is facing the light cutout. I recommend adding a small amount of super glue on these to keep them in place.Next I would recomment taking each translucent piece and gluing in the solid purple piece below it.While all of th