Minecraft TNT keychain

For this print make sure to add enough skirt layers and at least 2 skirt outlines, so the remaining red filament in the extruder cleen up and dont end up mixed with the white or else you´ll get a pink TNT label

Printed on a CR10s, using the color-raise technique (scripts) by pausing at certain layers in Simplify3D using the script:

{REPLACE "; layer" "M117 Layer"}

{REPLACE " Z = " " Z="}

{REPLACE "\nM117 Layer #, Z=" "\nG1 X10 Y5\nM0\nM117 Layer #, Z="}

Just change the POUND(#) symbols (there's two of them) for the number of the layer you want to pause your pint and then perform the filament change, then clic "resume printing", remember that the layer you set to pause is the layer where the new color starts.

If you want, for example, change color three times, you need to paste the same code three times. Remember always to change the POUND symbol

Print Settings

Printer brand:Creality

Printer:CR-10S

Rafts:No

Perimeters:3

Supports:No

Resolution:0.3