Minecraft Torch: LED flashlight, flame effect, 18650 battery

#Minecraft torch LED flashlight
##Flame effect
##18650 battery
##
## What you need
- Flame‑effect LED bulb (AliExpress / eBay, search for "fire led" or "candle led")
- 18650 battery (pre‑welded tabs recommended)
- TP4056 charging board with protection. It is strongly recommended to reduce the charging current to reduce heat; otherwise, the plastic may melt. The factory default is usually 1 amp. Replace the resistor (typically R3, 1 kΩ, marked "102") with one of a higher value, such as 3 kΩ (marked "302") for 400 mA.
- KDC11 switch (15×10 mm)
- 4x M3 screws
- Glue, wires, tape

## Printing and assembly tips
- **Main body and bottom** – brown or wood‑like filament (or paint later)
- **Bulb holder** – white filament (for better light reflection)
- **Top cover** – transparent PETG or other light-transmitting plastic
- Add a brim for the main long section.
- Add supports for the bottom section (where the switch is located).
- I tried to keep the size to a minimum, so it’s a tight fit. If it