Mini 2" Computer Speakers

https://vimeo.com/847567987

This is a speaker enclosure I designed

You can resize it to fit any speaker really

If you do make this be sure to post a make so I can see yours and leave any suggestions so I can make it better

REQUIREMENTS:

Basic understanding of soldering/soldering iron

Drill with drill bits

super glue/ hot glue

2" full range speaker 3 to 10 watts (anything over 10 watts is overkill and under 3 watts sounds bad)

amplifier depending on how many watts the speakers are, USB or battery powered is ideal

Speaker wire

spray paint (optional step, see directions)

Directions:

glue the two halfs of the enclosure together, OPTIONAL STEP: spray paint the enclosure the color you want it to be, I just did this because sometime the super glue will bleach the color of the PLA, then I drilled a hole to about 2-3 times the thickness of the wire this will act as a way to connect the speakers / as a port, next stick the wires from the amplifier into the