Thingiverse
Mini Airflow Funnel
by 3P3D
57
Downloads
48
Likes
0
Makes
This funnel is the same as the original airflow funnel except scaled at 50% (and the wall thickness is 75% of the original to retain some rigidity). Prints fine without supports.
The funnel shown in the pictures was printed on my Printrbot Simple at 15 mm/sec without supports, white PLA @ 173 C.
The funnel shown in the pictures was printed on my Printrbot Simple at 15 mm/sec without supports, white PLA @ 173 C.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
