Mini airplane 13.0

Version miniairplane 13.0 this time in the shape of a fighter F-35The wings must be printed on 3 layers for better strength, so the first layer is set to 0.12mm and the next layers to 0.08mm. This setting has worked for me several times.the plane consists of two parts, one part has an infill of 15% and a smaller part has an infill of 80%Before removing the model from the printing mat, wait for it to cool down, the miniairplane is easier to remove and the wings will not be crooked.The rear wings also have elevators, they can be bent as neededif the back part won't go in, use scissors and trim the pin a bit, use a drop of glue for better strength, but not necessary be careful with the cool plate, it is very difficult to removeYou can also use the included launcher For the launcher, you can also use a coarser rubber Check out my other models: https://makerworld.com/en/@Marek69