Mini Ambient Bucket Lamp

WARNINGThis model is for makers only! You have to use a soldering iron and might need to adjust the model in Bambu Studio to fit your electrical components. It is not print & play! Sometimes all you need it a shining bucket in the dark.This is an ambient bucket lamp. It uses a short LED strip and will run on 5V USB power.Besides the printed part you need:USB-C breakout-boardred & black isolated wire5V LED strip (recommended: 20LEDs or 330mm of a 60 LEDs/m strip)on/off switchoptional: 3x 5.5V, 1.5F, type-C supercapacitors (e.g. from Panasonic)soldering ironglue (e.g. hot glue)The print itself is very easy: Print the bucket in vase mode with a line thickness of 0.99mm for a 0.4mm nozzle. The rest can be printed normaly with 3 walls and no support. I recommend you use a brim on the clamps and the shaft to optimize bed adhesion. For assembly just clip the clamp on the bucket and glue them in place. Then you can install the handle. If you do not like the handle, just throw the handle and th