Thingiverse
Mini Amiga CD32 Case
door Overange
7
Downloads
4
Likes
0
Makes
WORK IN PROGRESS
This is a redesign of the original CD32 Case, it has been shrunk down to allow the A500 PCB to fit internally.
The dimensions of the case is :- 130mm x 88.9mm x 33.8mm
I have included the following STL Files
CD32_SMALL_HOLLOW - This is an unsplit version of the case. Vent grill has not been opened.
This is my own split.
CD32_SMALL_BOTTOM
CD32_SMALL_TOP - Grill has been opened with supports to allow ventilation.
CD32_SMALL_TOP_A500_Mini_PCB_HOLES - Rear Connector Holes have been made to fit the A500 Mini PCB, some work is needed to shift the connector holes over slightly to get it to fit perfectly, as well as removing the sides - photos do show this, as well as the crack when I was trying the get the PCB in. ( also think the filament must of failed to stick at that point?? )
It would also appear that the A500 Mini LED PCB will fit the same position and this case, to give a more realistic look.
No PCB Mounts or lid to base securing has been de
This is a redesign of the original CD32 Case, it has been shrunk down to allow the A500 PCB to fit internally.
The dimensions of the case is :- 130mm x 88.9mm x 33.8mm
I have included the following STL Files
CD32_SMALL_HOLLOW - This is an unsplit version of the case. Vent grill has not been opened.
This is my own split.
CD32_SMALL_BOTTOM
CD32_SMALL_TOP - Grill has been opened with supports to allow ventilation.
CD32_SMALL_TOP_A500_Mini_PCB_HOLES - Rear Connector Holes have been made to fit the A500 Mini PCB, some work is needed to shift the connector holes over slightly to get it to fit perfectly, as well as removing the sides - photos do show this, as well as the crack when I was trying the get the PCB in. ( also think the filament must of failed to stick at that point?? )
It would also appear that the A500 Mini LED PCB will fit the same position and this case, to give a more realistic look.
No PCB Mounts or lid to base securing has been de
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
