Mini B 2.0 wing mount

This was designed for Paul B’s carbon fiber rear tower.

Print with TPU for less breakage.
Print this wing with 20-30% infill for some flexibility.
I used two 15mm tapered screws so it stays centered in the tower holes. I found Long screws help with holding the wing mount on but also gives a little with any impact.
Not a perfect design but it should be fine for race scenarios, just print extra's and never be without a wing mount.
Stronger than you think and able to take an impact.

Edit - V2 is designed 5mm longer and cutout so you can put a washer and nut on the wing screws. I also gave this 3* of upward angle.

Edit - V3 is the long version without the cutout in it and with the 3* upward angle. I designed this because I use a tapered stainless wood type screw to hold the wing on and that same type screw to hold the mount to the tower.