Thingiverse
mini_bell_siphon
von turboprint3D
7
Downloads
3
Likes
0
Makes
I wanted to try a mini aquaponics system using fill and drain , using and if lift pump.
this bell siphon works good , has a 4mm drain with a velocity stack drain. works well with a low flow pump .
I used epoxy to mount to the tray .
https://www.youtube.com/watch?v=ZANYlj9han0
this bell siphon works good , has a 4mm drain with a velocity stack drain. works well with a low flow pump .
I used epoxy to mount to the tray .
https://www.youtube.com/watch?v=ZANYlj9han0
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
