Thingiverse
Mini Catapult - Trigger mechanism
von alex80it
13
Downloads
2
Likes
0
Makes
I printed this cool mini catapult by ATECH:
http://www.thingiverse.com/thing:438870
Then I designed some supports for the base, in order for it to be less flexible, and also so that the catapult could rest flat on the surface despite the rubber bands going under it:
http://www.thingiverse.com/thing:865607
The last thing I wanted to add was some sort of triggering mechanism, and so I designed this, taking advantage of one of the rubber bands used for shooting to also hold it into place.
Once held in tension, just press down the little lever on the back and the catapult will shoot!
http://www.thingiverse.com/thing:438870
Then I designed some supports for the base, in order for it to be less flexible, and also so that the catapult could rest flat on the surface despite the rubber bands going under it:
http://www.thingiverse.com/thing:865607
The last thing I wanted to add was some sort of triggering mechanism, and so I designed this, taking advantage of one of the rubber bands used for shooting to also hold it into place.
Once held in tension, just press down the little lever on the back and the catapult will shoot!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
