Thingiverse

Mini Drak Nose Camera Mount

di billyd

65 Download

49 Likes

0 Makes

This version splits the mount into a base and cover. The base is glued with goop to the mini drak after cutting off the nose. The cover screws to the base with 3x m2.5 screws (about 10-12mm long is plenty. The hex nuts are captured in the base and should be glued in place to they don't slide away from the hole. I use nylon screws and nuts to minimize weight. Rev B moves the location of the split closer to the rear of the aircraft allowing both cameras to be removed through the front when the cover is unbolted from the base. You no longer need a large hole behind the foxeer camera, just a tunnel for the camera cable into the bay.

This mount is designed for the foxeer 1177 with 2.5 or 2.1mm lens (or any narrower lens will work too) and the runcam2.

The reversed files switch the orientation of the cameras (from the original design shown in the photos Edit: First two photos show the reversed prints as of 4-21-17) and puts the runcam2 on the right side of the plane. This makes it poss

camera Camer Mount Foxeer Foxeer1177 MiniDrak Minidrak camera mount mount ritewing runcam2 camera Camer Mount Foxeer Foxeer1177 MiniDrak Minidrak camera mount mount ritewing runcam2 camera Camer Mount Foxeer Foxeer1177 MiniDrak Minidrak camera mount mount ritewing runcam2

Fonte

Thingiverse

Cosa serve per stampare: Intermedio Bassa affidabilità

Pezzo unico Viteria richiesta

Supporti 1/3

Assemblaggio 0/3

Impostazioni 1/3

Dimensioni piano 0/3

Post-lavorazione 1/3

Stampante

FDM / FFF

Formato file