Mini Fidget Catapult v2

Mini Fidget CatapultThis is a quick project that prints in 40 minutes and does not need AMS. Its functions include a sliding rail fidget and a high power rail launcher. The rail launcher slot also be used as a resistance sliding rail fidget. It will come off the build plate looking like this, inspect gear and pinion for any loose attached filament that you need to remove. Ensure that the coil spring's snap-in notch is facing the right way before removing it and sliding on the gear. Insert the gear+spiral spring into the bottom base through the axle and snap-in notch. The coil spring is slightly wider than the base, so it may be helpful to slightly wind the coil while inserting it. Place the top base over the assembled bottom base. Pinch hard between the top and bottom base to close. The bases take some force to assemble, but will not break if they are pressed together from the axle points. The rectangular part of the model will easily click in place once the circular parts are mesh