Thingiverse
Mini Figure 4 Wheeler
por Boomerjo
24
Descargas
21
Likes
0
Makes
This 4 Wheeler is design to go with Mobile Mini Figure v2.0 by azraelho published on Thingiverse on May 29, 2014.
It prints best on very high resolution at slower speed in PLA. The frame has designed in break away support structure so no need to add support structure for any of the parts when you slice them.
This is still a work in progress but you can see that I have printed and assembled it while tweaking the models.
Check out my mini-figure motorcycle too.
YES. The Wheels Turn.
Fun pandemic weekend project.
4 Wheeler is approx. 1 1/4" x 2" x 1 1/4" once assembled.
I've been printing with a .2 mm 1st layer height, .15 Layer Height, 50 m per second, 100% infill for the Motorcycle halves, figures. Handle bars etc. the Wheels I printed at a .2 layer height throughout.
Don't forget to use Soap to aid assy. where parts may be tight and Kragle (Krazy Glue) to secure items - use safely following manufacturer directions.
It prints best on very high resolution at slower speed in PLA. The frame has designed in break away support structure so no need to add support structure for any of the parts when you slice them.
This is still a work in progress but you can see that I have printed and assembled it while tweaking the models.
Check out my mini-figure motorcycle too.
YES. The Wheels Turn.
Fun pandemic weekend project.
4 Wheeler is approx. 1 1/4" x 2" x 1 1/4" once assembled.
I've been printing with a .2 mm 1st layer height, .15 Layer Height, 50 m per second, 100% infill for the Motorcycle halves, figures. Handle bars etc. the Wheels I printed at a .2 layer height throughout.
Don't forget to use Soap to aid assy. where parts may be tight and Kragle (Krazy Glue) to secure items - use safely following manufacturer directions.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
