Mini Filament Clip

**Very small but usefull Filament Clip printed in vase mode**

**Version 1.1**
14 I 2025

Uses around 0.4 gram of material

**This is my basic filament clip I use**
Can hold up to 4 strings

**Model is for 1,75mm filaments**
If you want to use it with **3mm filament** try resizing the model to **170-172%**
May be better to use bigger nozzle too (like 0.6mm or even 0.8)

---

**MiniFilaClip_v11** - basic model

**MiniFilaClip_v11_spool-clip** - with additional clip to use it on the spool
Should work with most spools

**MiniFilaClip_v11_tower_x10** - basic model x10 printed one on top off another
There is a visible line between segments. Use pliers (close to the line) to break each segment apart (tested only on PLA). For last two you may need two pairs of pliers

**MiniFilaClip_v11_x5** - basic model x5, each next to another printed at once
You will need a cutting pliers to cut off each segment

---

**Update 14 I 2025**
Now in version 1.1
Clip is little bigger and with some small change