Thingiverse
Mini FPV Camera holder
por cgapeart
5
Descargas
5
Likes
0
Makes
A slide-in holder for a combination FPV Camera/Transmitter with an adjustable tilt mount.
This was designed for a camera module purchased from Hobby King, approximately 20.3mm wide, 17.2 mm deep, and 8.2 mm thick where the built in antenna sticks out the top.
Camera designed for:
Adjustable Power 25mW / 200mW 5.8GHz 48CH NTSC/PAL Mini VTX FPV Camera Combo (Cloverleaf Antenna) https://hobbyking.com/en_us/adjustable-power-25mw-200mw-48ch-fpv-5-8ghz-wireless-camera.html?affiliate_code=YNLVCTWKGXBZWTQ
Two M2x4ish metric machine screws and nuts required. The inside in countersunk to make them sit flush.
There are bumps built into the top of the camera holder that you have to push the camera module past, and they should retain the camera.
This was designed for a camera module purchased from Hobby King, approximately 20.3mm wide, 17.2 mm deep, and 8.2 mm thick where the built in antenna sticks out the top.
Camera designed for:
Adjustable Power 25mW / 200mW 5.8GHz 48CH NTSC/PAL Mini VTX FPV Camera Combo (Cloverleaf Antenna) https://hobbyking.com/en_us/adjustable-power-25mw-200mw-48ch-fpv-5-8ghz-wireless-camera.html?affiliate_code=YNLVCTWKGXBZWTQ
Two M2x4ish metric machine screws and nuts required. The inside in countersunk to make them sit flush.
There are bumps built into the top of the camera holder that you have to push the camera module past, and they should retain the camera.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
