Thingiverse
Mini FPV Tri - V-Tail Conversion - 280mm - DYS
von MoRayCH
228
Downloads
171
Likes
1
Makes
As I really love the Mini FPV Tri by EMaglio, I decided to make a conversion kit to VTAIL, as I prefer VTAIL's over Tri's and Quads, for several reasons.
At first I didn't wanted to share it yet, as it is a rough prototype design, first draw. However once it was printed, and installed, it really looked awesome, I would even say BAD-ASS. So went ahead and shared it :)
Remember this is a WORK in Progress, I will improve the design.
Current Design, is made for the 280mm Arms and for DYS Motors (16mm mounting pattern).
Printed at 0.15mm Layer Height, in ABS,
At first I didn't wanted to share it yet, as it is a rough prototype design, first draw. However once it was printed, and installed, it really looked awesome, I would even say BAD-ASS. So went ahead and shared it :)
Remember this is a WORK in Progress, I will improve the design.
Current Design, is made for the 280mm Arms and for DYS Motors (16mm mounting pattern).
Printed at 0.15mm Layer Height, in ABS,
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
