Mini FT Arrow 3D Printed Mount Standard Width - Flitetest

Remix of AntonioSantos wider center pod for the FT Mini Arrow flying wing. This version is the right width for the standard fuselage without power pod.

I also set up a version with full height sides and holes, so the pod can be friction fit and secured by a piece of pushrod wire or bamboo skewer. if you use bamboo you will need to drill out the hole a little to the size you need.

Update: due to some experience with some crashy crashy, I revised the friction fit version to have a 2mm firewall rather than a 1mm. The firewall previously broke too easily.