Thingiverse
Mini Hacksaw
von noelc
1.1k
Downloads
687
Likes
10
Makes
This is a little hacksaw i made.
2 M3 screws are used for fixing the blade.
The blade is a 300 x 12.5 x 0.6 mm blade from amazon.
For printing:
I stopped the printing after 3.2mm and lay the blade into the slot. Then i continued the print with the blade. That garante that the blade fits into the slot. However, if your printer is good in printing bridges, this is not needed. Do this on your own risk ;)
2 M3 screws are used for fixing the blade.
The blade is a 300 x 12.5 x 0.6 mm blade from amazon.
For printing:
I stopped the printing after 3.2mm and lay the blade into the slot. Then i continued the print with the blade. That garante that the blade fits into the slot. However, if your printer is good in printing bridges, this is not needed. Do this on your own risk ;)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
