Thingiverse
Mini Japanese Lamp
von jacquesl70
60
Downloads
53
Likes
0
Makes
I saw someone build this on YouTube out of wood and I thought it will also work with 3d printing. https://www.youtube.com/watch?v=vj2umAt6Dsk
I printed 1 of Frame 1 and 1 of Frame 2 with a 30% fill.
You will need 4 of the large panels (1 or 2, 2 different designs) & 1 of the small panels.
The small panel was printed with a 30% infill, 3 layers.
I Printed the led panel with a 100% fill. The design uses the following design, https://www.thingiverse.com/thing:525799 and uses a CR2032 battery.
The led I used is a straw hat led, 160 degree 2.1 volt led using a 47 Ohm resistor.
You can use super glue to put it all together.
I printed 1 of Frame 1 and 1 of Frame 2 with a 30% fill.
You will need 4 of the large panels (1 or 2, 2 different designs) & 1 of the small panels.
The small panel was printed with a 30% infill, 3 layers.
I Printed the led panel with a 100% fill. The design uses the following design, https://www.thingiverse.com/thing:525799 and uses a CR2032 battery.
The led I used is a straw hat led, 160 degree 2.1 volt led using a 47 Ohm resistor.
You can use super glue to put it all together.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
