MakerWorld
Jewelry
Ver Modelo
Mini Jewelry Holder
0
Descargas
1
Likes
0
Makes
Jewelery Holder, can hold 4 chains or necklaces and upto 20 rings, although comfortably its 8.This is a very small print can fit it almost anywhere, base circle has a diameter of 80mm and it is also roughly 80mm tall, it could easily be scaled up to be taller and fit more rings or chains, but width will be difficult as it may make the bottom ring holders too wide to fit certain sizes No extra parts needed unless you use the JeweleryHolder-Seperate model, this variant prints the longer part upside down to reduce the amount of supports made, if you print this model, adhesive is required.If you print the JeweleryHolder-Connected model, nothing extra is required, although it uses slightly more plastic. I printed this in Black PLA
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
