Mini Ranger Car Keychain

NOTE:DO NOT CHANGE ANY PARAMETER SETTING OF THE .3MF FILE!, all changes that caused the failure of the print are your responsibility.You may need a pliers to remove the rear supports, BECAREFUL WHEN REMOVING THE SUPPORTS, as the rear are holding the keyring holder, you may also need to trim the shaft ends diameter, only if your wheels dont fit easily to the shafts/axle, this is difficulty may be caused by different types of PLA from various manufacturer, also the age of the filament that are exposed to humidity. Tools Needed : Nose Pliers if you have any suggestion regarding the improvement of this model,please comment down bellow and A mini Project of car KeyChain