Thingiverse
Mini RC Boat
door mtb_3d
49
Downloads
45
Likes
0
Makes
My newest design is this Mini RC Boat. It only measures 6cm x 4cm x 2.5cm and can all be printed within 45 minutes! It uses electronics that can be found in cheap RC helicopters. This model was designed to be printed in vase mode/spiraling outer contour mode. This design reduces leakage, reduces imperfections that could hinder performance, and the boat can remain quick to print and light weight. Check out my website, https://www.mattiatbutera.com for a more in-depth explanation or my Instagram https://www.instagram.com/mtb_3d/ for more projects!
Directions and Recommendations:
* ATTENTION: Print in VASE MODE/SPIRALING OUTER CONTOUR MODE. This worked perfectly for my Lulzbot Mini using a stock 0.5mm nozzle. You may need to change nozzle width
* Make sure you get the motors and propellers on the correct sides (watch Peter Sripol's blimp video it shows you: https://www.youtube.com/watch?v=EDiqHm9TqMg)
* Cut down small drone props for the propellers
* Look at the pictures ab
Directions and Recommendations:
* ATTENTION: Print in VASE MODE/SPIRALING OUTER CONTOUR MODE. This worked perfectly for my Lulzbot Mini using a stock 0.5mm nozzle. You may need to change nozzle width
* Make sure you get the motors and propellers on the correct sides (watch Peter Sripol's blimp video it shows you: https://www.youtube.com/watch?v=EDiqHm9TqMg)
* Cut down small drone props for the propellers
* Look at the pictures ab
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
