Mini Rubber Band Crossbow

Mini Rubbe band crossbow using a real nut axle trigger mechanism. The trigger relies on the flex of the PLA to act as a spring. it can launch tooth picks and pencils. AssemblyOnce all parts are printed assemble as shown in the pictures using two needles or pins ar pivot points, for my crossbow i used two sewing pins that i heated ove a candle to them through the other side, this made them stick better and prevent them from falling out, then i snipped the remaining lengh of the pins. the two small circles are spacers for the trigger and should go on either side of the trigger on the shaft.When placing the trigger ensure that the long part sticking out is inside the cross bow and can flex (it should act as a spring). For more indeph instructions reffer to the assembly guide attatched.