Mini Select Glass Bed Clamp

Mini Select V1 Glass Bed Clamp

As the only glass bed size available in my area is 210mm x 200mm x 3mm, I decided to made a glass bed clamp to hold the glass piece firmly.
It will be sufficient to just place it at the rear side while using normal clips to hold the front.
This is an extension of the 'mini G clamp' made by me earlier on at http://www.thingiverse.com/thing:2266210
Use PLA in all parts and print it in 100% ratio
Using glass bed is a tremendous improvement compare to stock mini or ordinary tape, which allow smooth and better 1st layer print, and an essential for ABS print as well.

Require:
Skid Protector x4, M2x16 screw x2, M2x8 screw x4, A2 nuts x8

Parts:
1. Body
-40% infill, with support
-disable brim to allow print in your mini
2. Others (Clamp surface x2, Screw RIngs x4, Knob x2)
-100% infill, without support