Mini Skyhunter - Replacement wing attachment retainers

!!! ADDITIONAL HARDWARE REQUIRED !!!

These have been designed to take a standard M4 nut. Therefore you will need to buy M4 screws of the correct length for this to work for you. You will also need to drill out the white washers on the wings to 4mm.

The print is tight enough that a press fit is enough to keep the nuts in place, however your printer's tolerances might be different to mine so I would always suggest you also secure the nuts with glue.

You will need both of the "rear attach" files as they are not simply identical, they're symmetrical.

I would suggest you glue these in place using goop or some other slow drying glue. The reason for this is that you should fit these into the fuselage and then immediately attach your wings, making sure to get the screws in place could require some movement + or - a mm here or there. Screw down the wings whilst the glue on these is still malleable/wet. Keep the wings attached/screwed on until the glue sets (preferably overnight), th