Thingiverse
Mini Talon Lightweight support cage
von HenrikJaderstrom
11
Downloads
4
Likes
0
Makes
This is a lightweight version of JAG_FPV's support cage, credits to him!
The rear spar hole are adjusted for a perfect fit, its to small in the original design.
I also designed a mounting plate for FC's with 30.5 x 30.5mm hole spacing and one for matek f405-wing with corners that forces the board to sit straight, use double sided foam tape for mounting the wing FC.
I put hexagonal holes for m3 nyloc nuts on the underside of the plates
The rear spar hole are adjusted for a perfect fit, its to small in the original design.
I also designed a mounting plate for FC's with 30.5 x 30.5mm hole spacing and one for matek f405-wing with corners that forces the board to sit straight, use double sided foam tape for mounting the wing FC.
I put hexagonal holes for m3 nyloc nuts on the underside of the plates
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
