Thingiverse
Mini Talon Motor Mount
by Av8er
12
Downloads
3
Likes
0
Makes
Remix to change inner mount pt to 33mm spacing for HK 28-35 Propdrive v2. Outer mount pt is still at 44mm.
Cut-outs are for M3 hex nuts. (5.5mm side to side) Std M3 nuts will fit flush but nylock nuts will be a little proud of the surface.
Use M3x12 button head screws (not the ones shown in the picture as cap head screws will hit the bell of the motor). The HK motor mount is 2mm thick, 12mm screws with nylock nuts will give a few threads sticking out. If your mount is thicker then you might need longer screws.
Put some tape over the back side of the nuts to keep the glue out of the nut threads.
If you want other bolt pattern size let me know.
Cut-outs are for M3 hex nuts. (5.5mm side to side) Std M3 nuts will fit flush but nylock nuts will be a little proud of the surface.
Use M3x12 button head screws (not the ones shown in the picture as cap head screws will hit the bell of the motor). The HK motor mount is 2mm thick, 12mm screws with nylock nuts will give a few threads sticking out. If your mount is thicker then you might need longer screws.
Put some tape over the back side of the nuts to keep the glue out of the nut threads.
If you want other bolt pattern size let me know.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
