Mini Talon Parachute Hatch

Mini Talon Parachute Hatch V3
========================

Installation instructions: [Click here!](https://imgur.com/a/QjhyY)

Introduction
----------------
This is a prototype version of a simple servo-controlled parachute/payload drop hatch to be mounted in the bottom rear of an X-UAV Mini Talon. It requires one 9g-Servo (I use a metal gear servo by KST) and a total of three screws (two to hold the servo, one for the hinge) to assemble.

Version History
--------------------

* 26.10.2017 - V1
> Initial Release
* 29.10.2017 - V2
> Lots of improvements
* 01.12.2017 - V3
> Even more improvements:
> * redesigned servo holder
> * greatly increased size to use all available space
> * increased stability
> * prints with less supports now
> * redesigned hinge: much stronger


Note: This is a work-in-progress! Use it at your own risk.
Print with supports, with the hole up (obviously).