Mini Trashcan

Here is a mini square trashcan. I personally made it to hold my used daily contacts and keep it on the bed side table instead of throwing them all over the floor. I found that using 1 magnet in the middle is strong enough to keep the lid in the closed position. Keep in mind the more infill you use on the lid, the more of a possibility you will need to add more weight (such as magnets) to the back. -The top portion is interchangeable with the different sized bottoms. I will be uploading different sized bottoms to make it bigger and smaller. Assembly: Insert 6x2 Magnets on both the cap and lid and superglue them in place. Align the Lid with the holes of the Cap and put a pin in on each side. then put the assembled cap on the bottom. Apply a little bit of superglue to the inside of the pin hole to keep them from falling out. Stay tuned for new versions. Feel free to like and follow for updates. Printer Settings: Material: PLA Infill: 7% Supports: Sorta Printer: Ender 3 Neo v1 If you find