Thingiverse
Mini vase
von Vijit
2
Downloads
0
Likes
0
Makes
You need to buy test probes for this thing. Current models for D12 probes, in the project you can set 12-16 diameter. Also you can change the cube size, 30-45mm. It depends on flowers you'll use. Current models has 35mm size. Note: the locks are one size for all.
The retainer and the "cubes" have intentionally different diameters, and the cube has a weakened size. It is easier to fit a narrow locking ring into a tight fit than a hole to the full depth of the cube.
A magnet lock for magnets 13x2mm, a screw lock for 3mm countersunk screws. With the blank lock use a double side adhesive tape.
The `teeth*` versions are experimental. A small contact spot near of the locks may not hold a vase, but they look interesting. Try it on your own risk.
Some cubes have sacrificial layers to print without support.
### Source
The source is [here](https://cad.onshape.com/documents/786af2f7ec0b5a5fb265e6e4/w/936f0e115a5d271c3db6e27c/e/dfdf7e3c23f4ceebc61e4b22).
#### How to use my configurable mode
The retainer and the "cubes" have intentionally different diameters, and the cube has a weakened size. It is easier to fit a narrow locking ring into a tight fit than a hole to the full depth of the cube.
A magnet lock for magnets 13x2mm, a screw lock for 3mm countersunk screws. With the blank lock use a double side adhesive tape.
The `teeth*` versions are experimental. A small contact spot near of the locks may not hold a vase, but they look interesting. Try it on your own risk.
Some cubes have sacrificial layers to print without support.
### Source
The source is [here](https://cad.onshape.com/documents/786af2f7ec0b5a5fb265e6e4/w/936f0e115a5d271c3db6e27c/e/dfdf7e3c23f4ceebc61e4b22).
#### How to use my configurable mode
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
