Thingiverse
Mini Watering Can
von royshearer
108
Downloads
69
Likes
7
Makes
A little 190ml watering can for watering your houseplant / deskplant.
I haven't yet made or modelled this as I don't have a makerbot. yet.
UPDATE: On closer inspection, I shortened the length so that it can fit in the makerbot build space. A slightly less pleasing capacity of 190ml (was 200!).
Have added a couple of feet on the back edge so that it can hopefully be printed sitting on its back, longest side sitting vertically. These should be cut or grinded off once printed. Comments welcomed below.
I haven't yet made or modelled this as I don't have a makerbot. yet.
UPDATE: On closer inspection, I shortened the length so that it can fit in the makerbot build space. A slightly less pleasing capacity of 190ml (was 200!).
Have added a couple of feet on the back edge so that it can hopefully be printed sitting on its back, longest side sitting vertically. These should be cut or grinded off once printed. Comments welcomed below.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
