Thingiverse
Mini Windowsill Satellites
von alreadytom
0
Downloads
0
Likes
0
Makes
Decided to shrink the Windowsill Satellites down to .055 on the ender3. this makes them about 40mm across on the base. the model is for printing a total of 2 full builds containing the follow parts. 4 side panels and 2 base units for top and bottom. I reinforced the base on the corners because the earlier versions the wall was too thin.
load in your Arduinos ESP32 or whatever you can fit. It sometimes nice to not just leave
stuff laying around. Put your hardware in the kit and explore it from your windowsill instead of a junk drawer.
load in your Arduinos ESP32 or whatever you can fit. It sometimes nice to not just leave
stuff laying around. Put your hardware in the kit and explore it from your windowsill instead of a junk drawer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!