Thingiverse
Miniature Church
von sinanislekdemir
32
Downloads
25
Likes
0
Makes
Okay, please don't mind the terrible printing quality in the photos. I am just too lazy to replace my old nozzle with a new one.
No supports needed. Just make sure you lay the objects onto the surface of the printing bed. So a few rotations and you are good to go. I rotated the roof about 48 degrees and it's perfectly level on the plate.
No cross on top. That would be too tiny and can get broken quite easily. So put whatever suits to your interest yourself.
No supports needed. Just make sure you lay the objects onto the surface of the printing bed. So a few rotations and you are good to go. I rotated the roof about 48 degrees and it's perfectly level on the plate.
No cross on top. That would be too tiny and can get broken quite easily. So put whatever suits to your interest yourself.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
