Miniature house lantern light

This is a Miniature house to use as a light source lantern.

in the photos i used battery powered flickering candle light, but you can use any small battery operated light Do Not use real candles

*what you need to print:
2 x side glass.
1 x front glass.
1 x top glass.
1 x bottom plate.
1 x back plate.
1 x roof.
1 x front wall.
1 x right wall.
1 x left wall.

*Assembly:
- use 4 pieces of M3x6mm to fasten the top holes of the walls.
- use 4 pieces of M3x8mm to fasten the bottom plates with the walls.
- use any clear crafting glue to stick the glass to the walls (just few little drops will do the job, do not over flow the glue.
- start fastening the back plate to the side walls then the connect the bottom plate to the walls.
- Roof does not need glue nor screws, i made it so it can sit on its place for you to open to put and remove the light.

hope you enjoy my design, and i appreciate your support, to encourage me to create more unique designs