Miniature storage Remix

Remixed the Storage System.
I wanted to save on printing time and filament so I created single shelves that slide in and out instead of the multipart system that exists. This removes the need to have a tray.
Also shortened the stacking shelves (the ones that take in the legs) by a little. Not sire

Initial shelf design was to maximize the 25mm minis.
Created a second shelf design to hold the large (50mm) minis.


Most of the legs are taken directly so you don't have to track them down directly.

I have two towers interlinked. Insides get 2x28mm each. Outsides get 60mm each.
Added a 4mm leg for the bottom row of the fist later that is offsetting. I'll take a pick and post it.

I hope you enjoy