Miniature Toothpick Crossbow

This is a miniature crossbow that shoots toothpicks.

I recommend printing it with PLA.

Do not use a rubber band for the bowstring. Use a small piece of string (not thread) that can fit through the hole in the bottom of the slider.

Use a piece of 1.75mm filament to attach the trigger to the frame. Then, wrap a small rubber band from the notch at the back of the trigger to the hook on the bottom of the handle.

Use two small pieces of filament and some super glue to attach the bow to the frame.

This model requires almost no support. However, I recommend printing the slider and the trigger with support.