Slicer Discord
Miniature Vacuum Ejector (Air Powered Vacuum Pump) – 3D-printbaar model van MakerWorld MakerWorld
Engineering

Miniature Vacuum Ejector (Air Powered Vacuum Pump)

67 Downloads
19 Likes
18 Makes
Model downloaden
I designed this little vacuum generator, also known as an ejector, for use with a vacuum cup for robotic manipulation. Blowing air in one side at 50 PSI will generate about 5 PSI of vacuum at the side port. The advantage of using a lightweight eductor right at the end-effector (as opposed to using a remotely located vacuum pump) is that you can control the vacuum action nearly instantaneously for faster pickup and eject times.It is only 1.225" long and weighs less than 5 grams. It's designed for use with 10-32 pneumatic fittings. (I've included the Solidworks part file for anyone wanting to optimize it or add mounting features.)PrintingUse a 0.35mm line width and a 0.2mm layer thickness. I used PLA, but ABS or PETG should work as well.Post PrintingAfter printing you will need to clean out the internal nozzle orifice with a 0.047" dia. drill bit. You will also need to tap the input and side vacuum ports with a 10-32 tap.Category: Engineering
Categorie
Engineering
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Gemiddelde betrouwbaarheid
Waarom?
supports nodig · 0.20mm lagen
Eendelig Supports vereist
Supports 2/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA, ABS, PETG
Laaghoogte
0.2 mm
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

LoboCNC publiceert ook op

313 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie