Minidisc Permanent front plate

This is front plate for a mindisc where you can take advantage of the whole front to add your label. This is a permanent change as you will no longer be able to re-record your disk. This is designed to be printed in Resin (ABS like). If you want to minimize the cleanum print it vertical but ancle the corners at least 10 degrees so that is not entirely flat. you can print it anywhere from 0.05 to 0.1mm layer height. After printing and cleanup, you can paint this. If using transparent resin you can add lacker to make it look even more transparent.

To assemble, follo these steps:

1. Record your album. (this is very important)
2. Pry open the minidisc (be careful)
3. Remove all the components and make sure you dont loose any.
4. Take the shutter and cut the top flap at roughly 3.5 mm from the edge ( Be extra careful)
5. Use the old back plate, then put the disk (make sure its in the correct orientation)
6. Add the shurrter latch piece (Top right corner)
7. Discard the record/pr