Thingiverse
miniFCU-Stand
por transwarp2010
0
Descargas
3
Likes
0
Makes
A miniFCU-Stand to raise it above the honecomb-bravo-yoke or other equipment. Prepared for the outer 3mm-Screws underneath the miniFCU-case.
The miniFCU-front is round about 15 cm above the ground, round about 11 cm at the back.
You can print it on the side without any support.
The miniFCU-front is round about 15 cm above the ground, round about 11 cm at the back.
You can print it on the side without any support.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
